We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 51824

14.2 Zynq IP - What are the units used in the UART receiver timeout error interrupt status?


On page 463 of the Zynq TRM (UG585) it states, "TIMEOUT: Receiver Timeout Error interrupt status. This event is triggered whenever the receiver timeout counter has expired due to a long idle condition".

However, what are the units of this timeout? Is this based on the baud_clock/bit_clock or the baud_sample?


The receiver timeout counter is based on baud_clock/bit_clock and not on baud_sample. This is shown in the diagram below:

AR# 51824
Date 09/14/2012
Status Active
Type General Article
Page Bookmarked