We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 52184

Zynq-7000 AP SoC ZC702 Evaluation Kit - How does SW16 correlate to jumpers J20,​ J21,​ J22,​ J25 and J26?


SW16 (light blue / grey 5-position DIP switch) is present on Rev D ZC702 and later revisions of the board (including Rev 1.0), as shown below:

Earlier revisions of the ZC702 Kit, such as Rev B or Rev C, do not have this DIP switch present. 
Instead, the mode is set using the jumpers immediately below the FMC headers, as shown below:

What is the relationship between switch SW16 and these five jumpers?


The equivalent jumper versus SW16 settings to set this board up correctly are listed below:

JUMPERS                 vs                            SW16

J26                                                              SW16-5

J25                                                              SW16-4

J22                                                              SW16-3

J20                                                              SW16-2

J21                                                              SW16-1

For information on the switch settings for various modes, please see (Xilinx Answer 46881).

Linked Answer Records

Master Answer Records

Answer Number Answer Title Version Found Version Resolved
47864 Zynq-7000 AP SoC ZC702 Evaluation Kit - Known Issues and Release Notes Master Answer Record N/A N/A

Associated Answer Records

Answer Number Answer Title Version Found Version Resolved
46881 Zynq-7000 Debug - How do I set up a third-party debug environment on the ZC702 board? N/A N/A
AR# 52184
Date 11/13/2017
Status Active
Type General Article
Boards & Kits
  • Zynq-7000 SoC ZC702 Evaluation Kit
Page Bookmarked