UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 52766

Zedboard - SDK - "Error while running xzynqresetstatus:" is seen when attempting to "Program FPGA"

Description

If "Error while running xzynqresetstatus:" is seen whenattemptingto "Program FPGA" on the Zedboard,this may be due to incorrect jumper settings on the board(JP7 - JP11).

Solution

By default, jumper settings on the Zedboard are setforSD Card. Please ensure the jumpers on the Zedboard are set correctly for the mode you intend to use.

You can check this in the Zedboard (Zynq Evaluation and Development) Hardware Users Guide, available here: http://www.zedboard.org/documentation

Example:

For the ZedBoard CTT: Thisrequires the jumpers to be set as Cascaded JTAG and so JP7 - JP11should all be set to GND.

AR# 52766
Date Created 11/05/2012
Last Updated 11/16/2012
Status Active
Type General Article
Devices
  • Zynq-7000
Tools
  • EDK