AR# 52967

Kintex-7 FPGA Embedded Kit - Jumper settings to run the Webserver based BIST and Video Demo application

Description

UG913 (V1.2), Getting Started with the Kintex-7 FPGA KC705 Embedded Kit, lists the default jumper settings required for running the Webserver based video demo application in the Video Demonstration Hardware Setup Instructions. Are these settings correct?

What are the correct jumper settings on KC705 board to run the Kintex-7 FPGA Embedded Kit BIST and Video Demo Webserver application?

Solution

The default jumper settings listed in UG913, Getting Started with the Kintex-7 FPGA KC705 Embedded Kit, are not correct.

The correct jumper settings are as follows:

Jumper 27	Short pins 2 and 3
Jumper 28	Short pins 2 and 3
Jumper 29	Short pins 1 and 2
Jumper 30	Short pins 1 and 2
Jumper 32	Short pins 5 and 6
Jumper 47	Short pins 1 and 2
Jumper 48	Short pins 2 and 3
Jumper 69	Short pins 1 and 2
Jumper 3	Short pins 1 and 2
Jumper 4	Short pins 1 and 2
Jumper 43	Short pins 1 and 2
Jumper 65	Short pins 1 and 2
Jumper 68	Short pins 1 and 2

UG913 (v2.0) has been updated with the correct jumper settings.

Was this Answer Record helpful?

Linked Answer Records

Master Answer Records

Answer Number	Answer Title	Version Found	Version Resolved
52970	Kintex-7 FPGA Embedded Kit - Known Issues and Release Notes Master Answer Record	N/A	N/A

AR# 52967
Date	02/26/2013
Status	Active
Type	General Article
Devices	Kintex-7
Boards & Kits	Kintex-7 FPGA Embedded Kit

Page Bookmarked