It is difficult to tell the boundaries of the I/O when I open the Device View for my design; the I/O seem to be on top of each other, or overlapping and jumbled together. This is true even if I zoom in close to only a few I/O.
This issue with overlapping I/O shown in the device layout has been seen in the 14.2 PlanAhead tool when the project target device was one of those listed below:
The issue has been fixed in the 14.3 PlanAhead tool.
AR# 52984 | |
---|---|
Date | 11/08/2013 |
Status | Archive |
Type | Known Issues |
Tools |