UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 5299

LogiCORE PCI - What loads should be used when maximum clock-to-out timing is calculated?

Description

General Description:

What loads should I use when calculating maximum clock-to-out timing?

Solution

The 5.0v PCI specification calls for the output buffer to be loaded with 50pF when clock-to-out timing is measured.

The 3.3v PCI specification (including the 66MHz spec) calls for the output buffer to be loaded with 10pF with a 25 ohm resistor in parallel.

AR# 5299
Date Created 08/21/2007
Last Updated 12/15/2012
Status Active
Type General Article