AR# 53960


14.x EDK, ChipScope - Is Cross Triggering enabled on Zynq and how is it done?


How do you configure the cross triggering between software and hardware (ChipScope) debug?

The debug configuration GUI in XPS tells me that there is no processor found that can co-debug with this IBA interface.

On the general settings GUI of the Zynq tab, I can enable the cross triggering signals of the Zynq PS, but the debug configuration GUI apparently does not recognize or cannot use these. Can I connect them manually, or how is this supposed to work?


Cross Trigger is not supported in 14.x, however, support should be added in 2013.1.

AR# 53960
Date 04/01/2013
Status Active
Type General Article
People Also Viewed