AR# 54036
Zynq-7000 AP SoC ZC706 - UG963 (v1.0) - SW11 switch settings incorrect for SD card boot
Description
UG963, ZC706 PCIe TRD User Guide (v1.0), outlines steps to program the Quad-SPI Flash Memory with files from the SD card to run the Zynq-7000 PCIe TRD from page 13.
Figure 2-3, page 14, shows the SW11 Quad-SPI Flash Memory Settings; however, these are incorrect in UG963 v1.0.
What are the correct SW11 settings to boot from the SD card?
Solution
In order to program the Quad-SPI Flash Memory with files from the SD card on the ZC706, SW11 needs to be set to 00110, as shown below:
54036-1.jpg
SW11 settings have been corrected in UG963, ZC706 PCIe TRD User Guide (v2.0).
Was this Answer Record helpful?
Linked Answer Records
Master Answer Records
| Answer Number | Answer Title | Version Found | Version Resolved |
|---|---|---|---|
| 51899 | Zynq-7000 AP SoC ZC706 Evaluation Kit - Known Issues and Release Notes Master Answer Record | N/A | N/A |
| AR# 54036 | |
|---|---|
| Date | 01/30/2013 |
| Status | Active |
| Type | General Article |
| Boards & Kits |
|