AR# 54922

14.x - Timing Tools - trce.exe crashes when generating timing report in GUI

I am receiving an error when I select "Generate Post-Place & Route Static Timing"

trce.exe has encountered a problem and needs to close.

How can I resolve this?

This is happening due to memory overload.

This problem can be solved by running trce.exe via the Command Line.

Where do I find the command line syntax?

At the top of any given twr, the command used to run trce is listed.
This is useful if you have previous reports available.
For more specific syntax questions see the Command Line Tools User Guide (http://www.xilinx.com/support/documentation/sw_manuals/xilinx14_4/devref.pdf).
The trce chapter begins on page 179.

Where do I find the command prompt?

Start -> All Programs -> Xilinx Design Suite -> ISE Design Suite 14.x -> Accessories -> 64-bit Command Prompt

Was this Answer Record helpful?

Page Bookmarked