We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 55329

Zynq-7000 AP SoC, Boot Sys - BootROM 128-KB CRC self-check is not supported


BootROM will not perform a full 128-KB CRC self-check of the ROM contents even if the corresponding eFuse bit setting is programmed in the PS.


Impact: Trivial. If there is a post-production bit failure in the ROM, then the behavior will be undefined instead of shutting down.
Work-around: Insert a DMB or DSB instruction between the write to Strongly Ordered memory region and the LDREX instruction.
Configurations Affected: Systems that use the CPUs.
Device Revision(s) Affected: Refer to (Xilinx Answer 47916) - Zynq-7000 AP SoC Silicon Revision Differences.

the ROM is tested and screened for manufacturing defects during production.

AR# 55329
Date 05/28/2013
Status Active
Type Design Advisory
  • XA Zynq-7000
  • Zynq-7000
  • Zynq-7000Q
Page Bookmarked