UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!
  1. Xilinx - Adaptable. Intelligent.
  2. Support
  3. AR# 61576: MIG 7 Series DDR3 - After re-customizing, ECC will become "Disabled" even though it was originally "Enabled"

AR# 61576

MIG 7 Series DDR3 - After re-customizing, ECC will become "Disabled" even though it was originally "Enabled"

Description

Version Found: MIG 7 Series v2.1
Version Resolved: See (Xilinx Answer 54025)

In some cases if ECC is "Enabled" for a MIG DDR3 AXI 72-bit design and then re-customized the MIG GUI will show that ECC is "Disabled".
 
MIG_ECC.png

Solution

This is an issue with the MIG GUI only, the correct configuration will be generated if you manually change the ECC setting back to "Enabled".

Revision History

07/29/2014 - Initial Release

Linked Answer Records

Master Answer Records

Answer Number Answer Title Version Found Version Resolved
54025 MIG 7 Series - IP Release Notes and Known Issues for Vivado N/A N/A
AR# 61576
Date 07/30/2014
Status Active
Type Known Issues
Tools
  • Vivado Design Suite - 2014.2
IP
  • MIG 7 Series
Page Bookmarked