You are using a deprecated Browser. Internet Explorer is no longer supported by Xilinx.
2.1i FPGA Editor - Autoroute returns "ERROR:FPGAEditor:356 - Nothing found to autoroute."
Keywords: autoroute, error, 356, nothing, found
When I select an unrouted net and attempt an autoroute, FPGA Editor returns the following error:
WARNING:FPGAEditor:313 - Failed to route net "GLOBAL_LOGIC0".
ERROR:FPGAEditor:356 - Nothing found to autoroute.
The error can be ignored, but the warning is a valid message. However, the NCD file is fine and can be run through BitGen without any problems.
This will be fixed in a future software release.
Was this Answer Record helpful?