UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 68026

SYSMONE4 Wizard - On-chip sensor VUSER supply tab does not accommodate 6V transfer function support

Description

The On-chip sensor VUSER supply tab of the SYSMONE4 Wizard does not accommodate support for the 6V transfer function.

Solution

When you select a HD bank as one of the VUSER supplies in the wizard, it should automatically set bits [3:0] of configuration register 44.


 

However in the IP these bits are not set:


 

In addition, the alarm limit range in the Wizard can only be selected up to a maximum of 1.8V. This is not enough for a HD bank.


 

This issue is due to be addressed in an upcoming release of the tools.

In the meantime the work-around is to manually instance in the RTL from the Wizard and do the following:

  • Set bits [3:0] of Config Register 4
  • Manually set the alarm limit based on the 6V voltage sensor transfer function

 
AR# 68026
Date Created 10/04/2016
Last Updated 11/01/2016
Status Active
Type General Article
Devices
  • Kintex UltraScale+
  • Virtex UltraScale+
  • Zynq UltraScale+ MPSoC
Tools
  • Vivado Design Suite
IP
  • System Monitor Wizard