UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 69164

Zynq UltraScale+ MPSoC ZCU102 Evaluation Kit - Jumper settings to support USB 3.0 HOST mode

Description

The factory default settings for the ZCU102 are not set up for HOST operation.

What jumper settings are required to support USB 3.0 HOST mode?

Solution

The following jumper settings are required on the ZCU102 to support USB 3.0 HOST mode operations:

J113Connect pins 1-2Meaning "Device or HOST" (NOT OTG)
J7Connect pins 1-2Meaning "HOST / OTG" (NOT Device)
J110Connect pins 2-3Meaning "Host Mode" (NOT Device or OTG mode)


 

For reference, below are the factory default jumper settings for USB OTG mode:

J113 is by default already in the correct position.

J7 is by default empty and it must be added.

J110 is by default in the incorrect position for USB 3.0 HOST mode and it must be moved as shown above.

Linked Answer Records

Master Answer Records

Answer Number Answer Title Version Found Version Resolved
66752 Zynq UltraScale+ MPSoC ZCU102 Evaluation Kit - Known Issues and Release Notes Master Answer Record N/A N/A
AR# 69164
Date 09/08/2017
Status Active
Type General Article
Boards & Kits
  • Zynq UltraScale Plus MPSoC ZCU102 Evaluation Kit
Page Bookmarked