How much margin is there in the D-PHY RX (or MIPI CSI-2 RX Subsystem) line rate settings?
For example:
Xilinx cannot give an exact margin number and highly recommends that users set the correct line-rate in the MIPI D-PHY RX GUI when configuring the IP.
Based on the MIPI D-PHY RX IP, the user should be able to see the following results when the line rate is set at the below rates:
Please keep in mind that these are only estimates and have not been tested or verified.
The recommended solution is to select the correct line-rate when generating the MIPI D-PHY RX in the IP GUI.
Answer Number | Answer Title | Version Found | Version Resolved |
---|---|---|---|
54550 | LogiCORE IP MIPI D-PHY - Release Notes and Known Issues for the Vivado 2015.3 tool and later versions | N/A | N/A |
65242 | MIPI CSI-2 Receiver Subsystem - Release Notes and Known Issues for the Vivado 2015.3 tool and later versions | N/A | N/A |
Answer Number | Answer Title | Version Found | Version Resolved |
---|---|---|---|
69525 | MIPI CSI-2 TX Subsystem - How is the Frame End generated? | N/A | N/A |
AR# 69530 | |
---|---|
Date | 04/09/2018 |
Status | Active |
Type | General Article |
Devices | |
Tools | |
IP |