AR# 71582

2018.2 LogiCORE IP MIPI D-PHY v4.1 (rev.1) MIPI CSI-2 RX Subsystem v3.0 (rev.3) - MIPI D-PHY RX or MIPI CSI-2 RX Subsystem reporting packet corruptions at higher line-rates


When the MIPI D-PHY or MIPI CSI-2 RX Subsystems IPs are used in slave mode, processed packets received from the sensor report intermittent data corruptions at higher line-rates (for example, 1500Mbps).

This occurs for designs that do not have I/O termination.


This issue occurs in the LogiCORE MIPI D-PHY RX and MIPI CSI-2 RX subsystem generated in Vivado 2018.2 and previous versions.

Internal termination of I/Os can be enabled using the below xdc constraints:

UltraScale+ devices:

set_property DIFF_TERM_ADV TERM_100 [get_ports <clk_rxp/n>] 
set_property DIFF_TERM_ADV TERM_100 [get_ports <data_rxp[*]/n[*]>]

7 Series devices:

set_property DIFF_TERM TRUE [get_ports <clk_rxp/n>] 
set_property DIFF_TERM TRUE [get_ports <data_rxp[*]/n[*]>

I/O termination is enabled by default in MIPI D-PHY RX and MIPI CSI-2 RX subsystems generated in the Vivado 2018.3 release.

AR# 71582
Date 01/21/2019
Status Active
Type General Article
Devices More Less