Vivado Design Suite Tutorial: Designing with IP (UG939) - 2021.1 English

Document ID: UG939
Release Date: 2021-07-19
Version: 2021.1 English

Revision History
Designing with IP Overview
Introduction
Tutorial Description
Hardware and Software Requirements
Locating and Preparing the Tutorial Design Files
Lab 1: Customizing the FIFO Generator
Introduction
Step 1: Open the Project
Step 2: Customize the FIFO Generator
Step 3: Instantiate IP into the Design
Step 4: Synthesize the Design
Conclusion
Lab 2: Creating and Managing Reusable IP
Introduction
Step 1: Start a Manage IP session
Step 2: Customize the FIFO Generator
Step 3: Customize the Clocking Wizard
Step 4: Use Third-Party Simulators
Get the Required Simulation Files
Structural Netlists for Simulation
Step 5: Add Additional IP
Step 6: Use Third-Party Synthesis Tools
Step 7: Create a Netlist Project
Create a Non-Project Third-Party Script
Conclusion
Lab 3: Scripting the Project Mode
Introduction
Step 1: Create a Project
Step 2: Add RTL Source Files
Step 3: Add XDC Constraints
Step 4: Add Existing IP
Step 5: Disable the IP XDC Files
Step 6: Upgrade an IP
Step 7: Setup Design Runs for IP
Create and Launch a Design Run for the Accumulator IP
Step 8: Launch Synthesis and Implementation
Step 9: Run the Script
Source the Tcl Script
Conclusion
Lab 4: Scripting the Non-Project Mode
Introduction
Step 1: Read the Design Source Files
Step 2: Add Existing IP
Step 3: Disable XDC Files
Step 4: Upgrade IP
Step 5: Create DCP for IP
Step 6: Run Synthesis
Step 7: Run Implementation
Step 8: Run the Script
Source the Tcl Script
Conclusion
Additional Resources and Legal Notices
Xilinx Resources
Documentation Navigator and Design Hubs
References
Please Read: Important Legal Notices

Back to home page