We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 37867

12.2 FPGA Editor - How do I bring a signal to an output pin for probing?


I wantto probe an internal signal in my design. What is the easiest way to bring this signal to an output?
Is it possible to bring the signal to more than one output?


To bring the signal to one output, use the Tools -> Probe command.
FPGA Editor does not support probing one signal to two or more pins. To work around this, probe a signal, save and close the ncd, then re-open the ncd and probe the same signal again.
AR# 37867
Date Created 09/28/2010
Last Updated 12/15/2012
Status Active
Type General Article