We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 58307

MIG 7series - IPI block design Interrupt signal direction is incorrect


Version Found: MIG 7 Series v1.9
Version Resolved: See (Xilinx Answer 54025)

With ECC enabled, MIG has a signal named Interrupt which should be output as per UG586

However, in the IPI GUI the Interrupt signal is incorrectly defined as an input which prevents users from connecting the interrupt to the IRQ_F2P input of ZYNQ.


This issue only arises with IPI designs.

As the RTL is correct, you can work around this by packaging the IP catalogue MIG and bringing it into IPI as a custom IP. 

Another option is to edit the <project>.srcs/sources_1/bd/<block diagram>/ip/<block diagram>_mig_7series_0_0/<block diagram>_mig_7series_0_0.xml file and change the lines below:








The interrupt input will then change to an output in the GUI.

Revision History

11/24/2014 - Initial Release

Linked Answer Records

Master Answer Records

Answer Number Answer Title Version Found Version Resolved
54025 MIG 7 Series - IP Release Notes and Known Issues for Vivado 2013.1 and newer tool versions N/A N/A
AR# 58307
Date Created 11/07/2013
Last Updated 11/26/2014
Status Active
Type Known Issues
  • Kintex-7
  • Artix-7
  • Vivado Design Suite - 2013.3
  • MIG 7 Series