UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 68512

DMA Subsystem for PCI Express (Vivado 2016.4) - Patch for various issues

Description

Version Found: 3.0 (Rev 1)

Version Resolved and other Known Issues: (Xilinx Answer 65443)

The tactical patch attached to this Answer Record addresses the following issues:

  • Issue with generation of ack for interrupts when multiple MSI-X vectors are pointing to the same MSI-X entry
  • Issue with PCIEBAR translation for BYPASS BAR
  • Issue with the XDMA_CONTROL parameter when AXI-LITE BAR is set to 64 bits
  • Issue with the interrupts when only MSI-X is selected for UltraScale+ devices
  • Issue with the Dword alignment when Bridge - Rootport mode is selected
  • Issue with the output signal axi_aresetn where it is being generated based on axi_aresetn from dma_top; it is now generated based on user_reset
  • Issue with simulations where 256bit data was compared for 512bit simulations
  • Added support for 128bytes DMA transactions
  • Issue with the continuous assertion of usr_irq signal in the legacy interrupt mode.




This article is part of the PCI Express Solution Centre

(Xilinx Answer 34536) Xilinx Solution Center for PCI Express

Solution

This is a known issue to be fixed in a future release of the core, please install the tactical patch attached as described below:

METHOD 1:

  1. Navigate to the $XILINX_VIVADO/patches directory (create this directory if it does not exist)
  2. Extract the contents of the ".zip" archive to a directory starting with the name AR68512
    Note: most extraction tools will allow you to automatically create a directory with the same name as the zip file
  3. Run Vivado software tools from the original install location.


METHOD 2:

  1. Create a separate directory for the patched files
  2. Extract the contents of the ".zip" archive to the desired patch directory location
  3. Set the MYVIVADO environment variable to point to the Vivado directory under this patch directory
    For example:
    set MYVIVADO=C:\MYVIVADO\vivado-patch-AR68512\vivado\
  4. Run Vivado software tools from the original install location.


Note: The "Version Found" column lists the version the problem was first discovered. The problem also exists in earlier versions, but no specific testing has been performed to verify earlier versions.

Revision History:

02/03/2017 - Initial Release

Attachments

Associated Attachments

Name File Size File Type
AR68512_Vivado_2016_4_preliminary_rev5.zip 2 MB ZIP
AR# 68512
Date 02/15/2017
Status Active
Type Known Issues
IP
  • DMA for PCI Express (PCIe) Subsystem
Page Bookmarked