AR# 68424

2016.4 Zynq UltraScale+ MPSoC: PMU Firmware build fails without "ENABLE_PM" macro

Description

The PMU firmware build will fail if ENABLE_PM is not defined.

Solution

The ENABLE_PM macro is required for almost all uses cases of the PMU firmware. 

If you require PM to be disabled, then the work-around is to move the "const XPfw_Module_t *PmModPtr" declaration outside of the "#ifdef ENABLE_PM" block in the file xpfw_mod_pm.c.

AR# 68424
Date 12/21/2016
Status Active
Type Known Issues
Devices
Tools